Tag Archives: ceramic

DIY Sharpie Decorated Mugs

Standard

Like many others, I spend too much time on Pinterest. Particularly, I spend too much time finding DIY crafts and home improvements. I’d seen before on Etsy mugs that had been redecorated. It wasn’t until Pinterest that I realized it might be a simple thing to do.

For this project, I used no one set of directions, but took advice from several sites and a friend who had done this project herself before besides. I used an ordinary Sharpie marker and white mugs (any colors would be fine, I’d guess, but I liked the black on white look, and the wedding registry listed white mugs, so I thought I wouldn’t mismatch the newlyweds’ kitchen too terribly). The mugs I used were both dishwasher and microwave safe but were ceramic not stoneware. I drew and wrote on the mugs. That bit needs no explanation.

A note to the wise, remove the stickers from the bottom of the mug before you start to draw on them and you won’t have to worry as I did about soapy water smudging the Sharpie as you try to scrub off the tack to prepare them to go into the oven.

I did find that scrubbing with a paper towel wet with soapy water did erase the marker when I wanted it to, but a drip of soapy water running down the side over the Sharpie had no effect.

This, I think, is wonderful. There are no do overs as clean with most traditional methods of ceramics painting.

I set my oven for 350 F, waited for it to preheat, put the mugs down on a cookie sheet, face-up, and waited anxiously for the crack that I was sure was coming.

In retrospect I ought to have set them in the oven on the cookie sheet, then turned oven on, and set the timer after the light went off, knowing as I do that you ought to let ceramic heat with the kiln rather than shoving cool clay in a hot kiln.

Doing so, though, made no noticeable difference.

I decided to twice-fire them, because, well, I hoped that maybe by doing so I could better set the marker and make it last longer. Only time will tell if it was worth it. This time I set the cookie tray with the mugs in the oven before turning it on. My oven, usually creaky, was making some noise as I waited for the light to go off. I got nervous, so I decided to heat the oven to only 300 F for the second firing.

I know enough about ceramics to know that I couldn’t open the door to peek, but I can’t tell you how tempting it was.

Between firings I was sure to let everything cool. I left the mugs on their tray in the oven and waited until the stovetop was as cool as if the oven hadn’t been turned on that day, then waited a bit longer besides to take them out, really waiting for the air inside the oven to cool to room temperature.

Neither time did the mugs crack.

The final result: Worth it.

DSCN6569